ALCON HYPER-RTV AUTOMATIC DOSE NEUTRAL LIQUID GASKET MAKER 200 ml. (MSDS)

ALCON HYPER RTV AUTOMATIC DOSE RTV LIQUID GASKET MAKER (TDS)

ALCON HYPER-RTV AUTOMATIC GREY LIQUID SEALANT 200 ML

Neutral Oxim-based next-generation liquid sealant.

Does not release any odors that could negatively affect sensors during curing.

Resistant to shrinkage and cracking caused by exposure to thermal cycling.

After curing, it works in temperatures ranging from -40°C to +300°C.

Developed with a resistant formulation, especially for oily and dirty surfaces.

After curing, it is resistant to oil, antifreeze, gasoline, diesel, and seawater.

Can be disassembled if necessary.

Strong adhesion, coverage, continuous elasticity, extra sealing.

Available in dosed automatic new cartridge packaging.

Technical Data

Colors: Red-Black-Grey

Curing: Neutral Oxim

Elongation at Break: 22

Viscosity/Appearance: Thixotropic paste

Density: 1.05 g/cm³

Elasticity: 450%

Initial Skinning Time: 15 minutes (+23°C)

Curing: 3 mm/day

Temperature Resistance: -40°C to +300°C

Extrusion Rate: 220 g/min

Application Surface Temperature: +5°C to +40°C

Application Method

Surface Preparation

Dust, oil, and dirt on surfaces that will come into contact with the liquid sealant should be cleaned.

Any residual sealant previously applied to the surfaces should be cleaned using mechanical methods.

Application Method

Apply the liquid sealant to a single surface. Wait for 5-10 minutes and then join the parts.

For small sealing surfaces, parts can be joined immediately if necessary.

Before application, open the packaging lid. Remove the safety seal. Adjust the required dosage using the gray ring. Press the plastic pedal to release the liquid sealant. When the pedal is released, the liquid sealant flow stops. To preserve the product for the next use, reset the dosage and close the packaging lid.

Areas of Application

For sealing all surfaces and filling corrosion gaps.

Used in automobiles, trucks, buses, military vehicles, ships, machinery, heating systems, industrial furnaces, and chimneys.

For sealing sensitive surfaces exposed to high heat or temperature fluctuations, and surfaces that require sealing but where rubber, cork, or Klingerit-type seals cannot be applied.

Used in all engine sealing areas, differential covers, carburetor caps, pumps, thermostats, gear and transmission boxes, and surfaces exposed to vibration and heat.

Warnings

Do not throw full/empty packaging into fire. Keep away from direct sunlight and store at temperatures not exceeding +50°C.

Keep out of reach of children.

Store in a well-ventilated area.

Keep away from ignition sources and do not smoke.

Avoid contact with eyes and skin.

In case of eye contact, immediately rinse with plenty of water and consult a doctor.

Wear appropriate protective clothing, gloves, and goggles/mask while working.

In case of an accident or if you feel unwell, immediately seek medical attention.

If swallowed, immediately consult a doctor and show the container or label.

Do not pour into the sewage system. Dispose of waste and packaging according to local hazardous or special waste disposal regulations.